A332 battery for electronic devices

The A332 battery is alkaline and is used in various electronic devices. Its large size allows for a high capacity. capacityThis allows for long-term and stable operation.

Characteristics of the A332 Era battery and its analogs

Below are the basic data on the replacement and main battery a332.

Parameter name	Meaning
Service life	Before use, it retains its properties for up to 1 year.
Diameter	21 mm
Length	37 mm
Weight	35 g
Voltage	1.5 volts
Capacity	1.8 mAh
It will function if operated continuously.	Around 15:00.
Size and Form Factor	LR10/C
Electrolyte type	Alkaline, saline

This element is cylindrical. The positive terminal has a protrusion. The surface is covered with a film wrapper. The label contains all the main parameters.

The letter A means that this is a manganese-zinc system with an alkaline electrolyte.

Capable of operating at +50 degrees Celsius and -10 degrees Celsius. Storage humidity should not exceed 98%.

The structure of the A332 battery

The entire battery casing, a 332, is made of metal. It serves both as a conductive element and as a protective device. A paste diaphragm, a negative terminal, and its current collector are built into the positive electrode. The negative terminal and its conductor are insulated with a special vinyl plastic plate to prevent short circuits with the positive terminal.

1. Pad.
2. Negative current collector element.
3. Negative electrode.
4. Ion-conducting diaphragm.
5. Positive electrode.
6. Sticker or label.
7. The bar is resistant to temperature fluctuations.
8. Sealed unit.

The battery is sealed by clamping a special gasket between the case and the metal cover. The entire assembly rests on the negative electrode's current-carrying element.

In some cases, the lid is nickel-plated to provide additional contact. This allows for longer life and a more attractive appearance.

Where is the 332 battery used?

Due to its high capacity, this energy source has become widespread in everyday life. It is used in:

1. Lanterns.
2. Radio receivers.
3. Electrical DIY.
4. Toys.
5. Medical equipment.
6. Multimeters.
7. Libra.

In addition to these devices, it can also be used in other devices, the main thing is that the dimensions and voltage are suitable.

Analogues of the 332 era battery

There are several types of substitutes:

1. LR10 is essentially a standard size.
2. 332
3. LR21
4. FBS-0.25
5. 1.3 FMC-0.25

These batteries can replace the Era A332.

The main domestic data elements are called "ERA" and "PRIMA".

Is there any point in charging?

If you've managed to find the correct rechargeable battery type, then charging it is entirely possible. However, if you have a regular saline or alkaline battery, you won't be able to recharge it. The only thing that can give it a little boost is heating it with either an electric current or regular heat.

But this is a rather dangerous activity, since if you overdo it a little, it may leak or completely stop producing the required charge.

What should not be done with the A 332 battery?

There are a number of operating requirements. In general, here's what's prohibited:

1. Short circuiting is not allowed.
2. Perform discharge below 1 volt.
3. To disassemble.
4. Throw into the fire.
5. Do exercises.
6. Heat strongly.
7. Install in a poorly holding battery container.

Thus, the 332 battery can be used in everyday life while observing all necessary safety regulations.